Stylus Pro 4880 Field Repair Guide 1/17/08
Multi Sensor Level Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 153.
Multi Sensor Level Adjustment
Note: This adjustment sets the “White Level” for the Multi Sensor (sensitivity calibration).
1. Load 17” Enhanced Matte roll paper.
2. From the Adjustment Wizard for the Pro 4880, select the Multi Sensor Level Adjustment
1. Click on the Run button.
2. The Printer will sample the paper with the
Multi Sensor to set a reference level.
3. The Printer will print out the data that was
written to the board. It will look like this.
4. Click the Finish button.
To Next Page
Loading...
