Epson Stylus Pro 4880 - T&B&S [Cut Sheet] Adjustment

Stylus Pro 4880 Field Repair Guide 1/17/08
T&B&S [Cut Sheet] Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 186.
T&B&S [Cut Sheet] Adjustment
Note: This function sets the top, bottom, and side margins for cut sheet paper.
1. Load A4 Enhanced Matte cut sheet paper.
2. From the Adjustment Wizard for the Pro 4880, select the T&B&S [Cut Sheet].
1. Click on the Print button.
2. The Printer will print out this pattern, and mea-
sure the side margin using the Multi Sensor.
3. Measure the top (leading edge) margin, and
enter the value measured.
10. Click the Finish button.
4. Measure the bottom (trailing edge) margin, and
enter the value measured.
5. Enter the side margin value printed on the print
out, labeled “Side Margin Adjust”.
7. Repeat Steps 1 - 4.
8. Measure the side margin, and enter the value.
6. Click the Write button.
9. Click the Write button.