Stylus Pro 4880 Field Repair Guide 1/17/08
Nozzle Bi-D Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 156.
Nozzle Bi-D Adjustment
Note: This adjustment calibrates the Auto Nozzle Check Function.
1. Load 17” Enhanced Matte roll paper.
2. From the Adjustment Wizard for the Pro 4880, select the Nozzle Bi-D Adjustment.
1. Click on the Print button.
2. The Printer will print out this pattern.
3. Inspect the pattern and identify the value that
represents the most vertically straight line. It is
possible to choose an odd number that would
represent a value between the even printed
6. Click the Finish button.
4. Enter the value from step 3 here.
5. Click the Write button.
Note: If none of the lines are straight, pick the line that is closest to straight, and write the value. Then
reprint and try again. Each time the patterns should be closer. Repeat again if necessary, until
To Next Page
Loading...
