Stylus Pro 4880 Field Repair Guide 1/17/08
Platen Gap Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 163.
4. Press and hold the Left, Down, and Up buttons, and turn on the Printer (Maintenance Mode 2).
5. Using the Down button, navigate to Self Testing: Adjustment: and press the Menu button.
6. Using the Down button, navigate to ADJ: PG ADJ: and press the Menu button.
7. The Printer’s LCD will display [ENTER] Start.
8. Press the Menu button to start the procedure.
8.1 The Printer’s LCD will display Detecting Origin.
8.2 The Printer’s LCD will display PG Offset *(nn) (*nn = the current Platen Gap Offset).
9. Place a.65mm feeler gauge on the Platen as shown.
1. Slide the Carriage Assembly towards the feeler
gauge.
2. Increase the Platen / Print Head gap by depressing the
Up Arrow
3. Continue to increase the gap until the Print Head clears
the.65mm feeler gauge.
4. Increase the Platen Gap Offset Value be 3 more steps
than determined in step 3.
To Next Page
Loading...
