Stylus Pro 4880 Field Repair Guide 1/17/08
Board (Main) Installation Printer Component, Software Item, LCD Display, Printer Button Page 18.
6. Write current Firmware to the Main Board. (Detailed directions for writing firmware to the Main
Board are in the Firmware Update chapter located in the Reference Section of the Field Repair
Guide.
6.1 Open the FW/Update.exe, and prepare to send the current firmware version to the Printer.
6.2 Turn on the Printer while depressing the Left, Up, Down, and Right arrow buttons, The Printer will display
UPDATE F/W.
6.3 Send the current firmware to the Printer.
If the Printer’s Parameters are not available skip step 7, and follow step 8 and 9.
7. Re-Install the Printer’s parameters using the Parameter Backup / Restore Utility (Nvram.exe)
7.1 Perform the RTC&USBID&IEEE1394ID Adjustment.
8. Install the appropriate generic Printer parameters using the Parameter Backup / Restore Utility
(Nvram.exe)
Note: If the new Board does not have any parameters, the Printer may not function well enough to allow
alignments, paper loading, nozzle check, or the rest of step 18. Generic parameters are a set of
working parameters from another printer. They are available for download at: https://
www.epsoninsider.com listed under the Printer name, as Generic NVRAM Backup. They come in 2
variations (4880 Matte Black, 4880 Photo Black).
9. Perform the following operations in the order listed.
9.1 Perform the RTC&USBID Adjustment.
9.2 Perform the Rear Sensor Calibration.
9.3 Perform the Cutter Pressure adjustment.
9.4 Perform the Platen Gap adjustment.
9.5 Enter the Head Rank ID (Print Head calibration values).
To Next Page
Loading...
