Stylus Pro 4880 Field Repair Guide 1/17/08
Print Head Replacement Procedure Printer Component, Software Item, LCD Display, Printer Button Page 86.
12. Disconnect the Print Head Cables
13. Connect the new Print Head to the Cables. Ensure that the 0 Cable is on top (Nozzle Plate side).
14. Attach the Print Head to the Head Case.
15. Attach the Head Case to the Carriage Mechanism.
16. Re-install the Carriage Mechanism.
16.1 Ensure that the Timing Strip is routed through the Sensor.
16.2 Use the Carriage Rail Cover protection jig.
17. Place the Carriage Belt on the Carriage Motor Pulley.
18. Tighten the Carriage Belt until the Gauge reaches the mark that represents the proper tension.
Gently remove the
Cables.
The Top Cable is the 0
Cable.
To Next Page
Loading...
