Epson Stylus Scan 2000 - Adjustment

EPSON Stylus Scan 2000
Revision A
Disassembly & Assembly
Disassembly Procedures
112
Figure 4-14. Installing the PG Lever
Figure 4-15. Removing the Carriage Assembly
To the PG
Lever
Insert this side to
the hole on the
right frame.
EPSON Spring 63.7
PG Lever
PG Support
Lever
Elliptic Holes
Carriage Assembly
CR Guide
Shaft
Left Parallelism
Adjustment Bushing
Right Parallelism Adjustment
Bushing
Washer
[Convex side should face to the bushing
side during installation]
PG Support Lever