Epson Stylus Scan 2000 - Error Is Detected

EPSON Stylus Scan 2000
Revision A
Troubleshooting
Unit Level Troubleshooting
64
3.1.2 Error is detected
Flowchart 3-2.
3.1.3 Failure occurs during printing
Flowchart 3-3.
Start
Yes
Check the LCD
message and refer
to Table 3-1.
Is the
problem carriage
related?
Yes
No
No
No
No
No
Yes
Yes
Yes
End
End
Turn off the Stylus
Scan and move the
carriage by hand.
Does it
move smoothly?
See Table 3-3.
Does it
move smoothly?
Does it
move smoothly?
Is it an ink
cartridge error?
Maintenance Error
Replace the waste ink
pads and reset the
counter. See Section
4.2.2.1 on page 93.
Check the ink
cartridge sensor and
replace the printhead
if necessary.
Replace the ink
cartridge.
Replace MAIN
board if the CR
motor operates
properly.
Start
Yes
Print a self
test.
Did it print
properly?
No
Is
print quality
normal?
No
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
End
End
End
Perform adjustment.
See Section 5.2 on
page 119.
Perform cleaning.
MAIN
board cables
are OK?
Connect them.
Problem
solved?
Refer to Table 3-3.
Problem
solved?
Replace the
MAIN board.
Problem
solved?
Problem
solved?
Problem
solved?
Replace the ink
cartridge and
print self test.
Refer to Table 3-3.