6.2 Cleaning
This section describes the points and the procedures for maintaining the printer in its
optimum condition.
6.2.1 Exterior
Use a clean soft cloth moistened with water and wipe off any dirt. If the housing is stained
with ink, use a cloth moistened with neutral detergent to wipe it off.
6.2.2 Inside
Inside the printer:
Use a vacuum cleaner to remove any paper dust.
6.2.2.1 Printer Mechanism
The printer mechanism has no mechanical components which require regular cleaning.
Therefore, keep the above points in mind and perform cleaning when necessary.
6.2.2.2 Scanner mechanism
Perform cleaning if a noticeable stain appears on the scanner mechanism and especially if
dirt, ink, etc. are on the document glass. Objects or stains on the document glass mar output
quality; therefore, be sure to clean the glass thoroughly to remove any objects or stains.
o Document Glass
Remove dust and paper debris with a clean, dry cloth. If a stain remains or a
foreign object is stuck, use a neutral detergent and try cleaning again. Finally, wipe
the glass surface with a dry, clean cloth to remove any moisture.
n Never use chemical solvents, such as thinner, to clean the printer.
These chemicals can damage the components of the printer.
n Be careful not to damage the components when you attempt to
clean the inside the printer.
n Do not scratch surface of “ROLLER, ASSEMBLY, PF”. (Use soft
brush to wipe off any dusts, or use a soft cloth moistened with
alcohol.)
Never apply any organic solvent such as thinner or benzine, since
they may damage or deteriorate plastic and rubber parts.
To Next Page
Loading...
Need help?
General
