Rev.D Assembly and Disassembly 2-67
TM-U675/U675P (with autocutter) Service Manual
Confidential
30. While aligning the three nibs shown in the illustration, attach the front reinforcement frame
to the front frame and secure them with six screws. When doing so, make sure the nibs and
claw you aligned in the previous step (step 29) are still aligned.
31. Tighten the two screws to secure the slip guide upper frame.
32. Attach the endorsement platen shutter to the slip guide upper frame.
Figure 2-67
611
Carriage spring
691
Front cover detector assembly
691
Front cover detector assembly
654 Paper feed roller spring
Nibs
To Next Page
Loading...
