Epson TM-U675 - Pre-Assembly of the J;S Change Solenoid Assembly

2-6 Assembly and Disassembly Rev.D
Confidential
Pre-assembly of the J/S Change Solenoid Assembly
1. Attach the J/S change solenoid to the J/S solenoid mounting plate. When doing so, tighten
the screw while the J/S change solenoid is touching the nib on the right side of the J/S
solenoid mounting plate.
2. Attach the J/S change lever to the J/S solenoid mounting plate, and hook the J/S change
spring.
3. Lubricate the sliding part of the J/S change solenoid mounting plate and the J/S change
lever in four places.
Figure 2-5
651
J/S change spring
716
Screw (C.C., 2X3)
727
J/S change solenoid
774
J/S solenoid mounting plate
650 J/S change lever
G-36
G-36