Rev.D Product Overview Appendix D-25
TM-U675/U675P (with autocutter) Service Manual
Confidential
Slip Feed Mechanism
The slip feed mechanism is comprised of the following parts:
❏ Form stopper
❏
Sub slip feed lever
❏
Sub slip feed roller
❏
Sub slip hold roller
❏
Slip feed roller
❏
Slip hold roller
❏ Paper feed motor and wheel
Positioning slip paper
The slip paper path is normally interrupted by the form stopper, located perpendicular to the
path, which is held in place by the form stopper spring. When a slip is inserted along the right
edge of the slip guide lower frame in the direction indicated by the arrow, the slip paper goes in
as far as the form stopper and is positioned. (See Figure D-34.)
When the paper feed motor rotates several times forward and reverse while energizing the J/S
change solenoid, the J/S change lever will switch the J/S change gear that had been engaged
with the roll paper feed gear so that it is engaged with the slip paper feed gear. (See Figure D-
35.)
Figure D-34
Paper feed trigger attraction plateLever drive cam
Slip feed roller
Slip hold roller
Sub slip hold roller
Slip guide upper frame
Slip paper
Slip guide lower frame
Sub slip feed roller Sub slip feed lever
Lever drive coil
Form stopper
T.O.F. detector
assembly
B.O.F. detector
assembly
a
b
To Next Page
Loading...
