Epson TM-U675 - Pre-Assembly of the Carriage Frame Unit

2-14 Assembly and Disassembly Rev.D
Confidential
Pre-assembly of the Carriage Frame Unit
1. Lubricate the carriage motor shaft.
2. Insert the carriage drive pulley into the carriage motor shaft.
3. Lubricate the inside of the carriage drive pulley.
4. Attach the belt drive cap to the carriage drive pulley and secure it with one E-ring. Place the
belt drive cap with flat surface face up to install it.
Figure 2-13
720
E-ring (2)
603
Belt drive cap
633
Carriage drive pulley
733
Carriage motor
G-36
G-36