Epson TM-U675 - Pre-Assembly of the Paper Feed Motor

Rev.D Assembly and Disassembly 2-5
TM-U675/U675P (with autocutter) Service Manual
Confidential
Pre-assembly of the Paper Feed Motor
Note:
Perform the following three steps only if your printer has a MICR unit.
1. Insert the paper feed motor into the motor shield case. Insert the paper feed motor gear into
the hole in the motor shield case. Check that the motor printed circuit board (PCB) fits into
the notch.
2. Insert two motor shield spacers into the motor shield case.
3. Attach the motor shield cover onto the motor shield case (two places). Align the screw holes
and the nibs on the opposite side, and push in so that they snap fit.
Figure 2-4
781 Motor shield cover
725
Screw (C.C.S-tite, 2.5X5)
739
Paper feed motor
780
Motor shield case
779
Motor shield spacer
726
Screw (C.B.S-tite F, 3X6)