Appendix I-6 Printer Handling Rev.D
Confidential
9. When using 2-ply roll paper, insert the end of the journal paper into the take-up spool as
shown below. Be sure that 40 to 60 mm (1.5 to 2.25 in.) of paper extends beyond the spool
and that the right side of the paper is against the spool’s flange.
Figure I-9 Inserting the end of the journal paper into the take-up spool
10. Insert the take-up spool and cut off the receipt paper, as shown below.
Note:
When installing or replacing the roll paper, use the manual cutter to cut the receipt paper. If you cut
the receipt paper using the emergency cutter on the autocutter after closing the roll paper cover, there
is the possibility of causing a paper jam.
Figure I-10 Inserting the take-up spool
11. Close the roll paper cover.
spool
Manual
cutter
To Next Page
Loading...
