Epson TM-U675 - Closing the Roll Paper Cover; Installing or Replacing the Paper Roll

Rev.D Printer Handling Appendix I-3
TM-U675/U675P (with autocutter) Service Manual
Confidential
Closing the Roll Paper Cover
Note:
If you do not close the roll paper cover using the following procedures, a paper jam can occur.
1. Check that the power to the printer is turned ON. If it is not ON, turn it ON.
2. Press the FEED button to feed approximately 50 mm of roll paper. (this work is not
necessary if you replace or install the paper roll because paper feeding occurs automatically
when you insert paper into the roll paper slot.)
3. Cut the receipt paper with the manual cutter shown below.
Figure I-4
4. Close the roll paper cover. Press down on the roll paper cover until you hear a click.
Installing or Replacing the Paper Roll
You need to install a paper roll even if you are using only the slip or validation sections of the
printer.
Note:
Do not use paper rolls that have the paper glued or taped to the core because they might cause a paper jam.
1. Make sure the printer is turned on.
2. To prevent data loss make sure that the printer is not receiving data.
Manual
cutter