Epson TM-U675 - Arranging the Cable Wires; Procedures for Replacing the Print Head Unit; Pulling the Cable Connector out; Removing the Ribbon Cartridge

Rev.D Troubleshooting 1-15
TM-U675/U675P (with autocutter) Service Manual
Confidential
Procedures for Replacing the Print Head Unit
1. Turn off the power switch to the printer. Remove the power supply unit from the printer.
2. Open the printer front cover and remove the ribbon cartridge.
Figure 1-5 Removing the ribbon cartridge
3. Pull the cable connector out of the slit in the case.
Figure 1-6 Pulling the cable connector out
When you are reattaching the cable, arrange the cable wires as shown below.
Figure 1-7 Arranging the cable wires