Epson TM-U675 - Pre-Assembly of the Lever Drive Coil Assembly

2-4 Assembly and Disassembly Rev.D
Confidential
Pre-assembly of the Lever Drive Coil Assembly
1. Attach lever drive coils (type A, B) to the lever coil mounting plate sub assembly. The rack
for lever drive coil (type A, B) should face upward. Do not confuse type A and B. Type A
uses brown lead wires. Type B uses gray lead wires.
2. Assemble the paper feed trigger attraction plates to the lever drive coils (type A, B).
3. Hook paper feed trigger claw springs onto the lever coil mounting plate sub assembly and
paper feed trigger attraction plate. One side of the hook on the paper feed trigger claw
spring is single and the other side is double. Attach the double side onto the paper feed
trigger attraction plate.
4. Lubricate the areas where the paper feed trigger attraction plate contacts other parts (eight
places).
Figure 2-3
G-36
G-36
G-36
732
Paper feed trigger attraction plate
732
Paper feed trigger attraction plate
621
Lever drive coil (type A)
622
Lever drive coil (type B)
731
Paper feed trigger claw spring
731
Paper feed trigger claw spring
695
Lever coil mounting plate sub assembly