Epson TM-U675 - About this Chapter; Procedures; Before Assembly and Disassembly; Chapter 2 Assembly and Disassembly

Rev.D Assembly and Disassembly 2-1
TM-U675/U675P (with autocutter) Service Manual
Confidential
Chapter 2
Assembly and Disassembly
Before Assembly and Disassembly
Always observe the following precautions when disassembling and assembling the printer.
CAUTION:
Always remove the power supply unit from the printer before working. Power is flowing
in the internal circuit board even if you turn the printer off with the power supply switch.
You can damage the printer if you work with the power supply still attached.
Remove all peripheral equipment connected to the printer before starting your work.
Do not perform any work that is not described in this chapter. Doing so can result in
injuries or damage to the printer.
Do not touch the FPC or the FFC pins with your hands.
About this Chapter
Procedures
This chapter provides the procedures for assembling. Reverse them to disassemble the printer.
Assembly is organized into “Assembling the Mechanism Assembly (M-U675),” and
“Assembling the TM-U675.” Each section is further divided into “Pre-assembly” and
“Assembly.”
Do “Pre-assembly” steps first, and then do “Assembly” after you have assembled the parts into
units to some degree.