2-72 Assembly and Disassembly Rev.D
Confidential
42. Lubricate the shaft shown in the figure.
43. Inset the J/S change gear onto the shaft shown in the figure.
44. Insert the paper feed reduction gear into the shaft shown in the figure with the gear whose
diameter is largest in.
45. Insert the take-up drive gear into the shaft shown in the figure.
46. Insert the paper feed transmission gear into the shaft shown in the figure.
47. Attach the gears with four E-rings (3).
Figure 2-72
646 Take-up drive gear
721 E-ring (3)
721 E-ring (3)
721 E-rings (3)
728
J/S change gear
637 Paper feed transmission gear
721 E-ring (3)
G-36
729 Paper feed reduction gear
To Next Page
Loading...
