Epson TM-U675 - Page 121

Rev.D Assembly and Disassembly 2-87
TM-U675/U675P (with autocutter) Service Manual
Confidential
71. Insert the paper feed frame shaft into the platen unit.
72. Attach the platen unit to the main frame. Attach the platen unit as you widen both sides of
the frame and fit the D shaped portions on both ends of the shaft into the D shaped cutting
holes on the frame.
73. Tighten one screw from the right side of the main frame and fasten the paper feed frame
shaft.
74. Position the two nibs and attach the assist frame sub assembly with two screws.
Note:
The assist frame sub assembly is not included in the mechanism assembly supplied as a service part.
For that reason, replace the mechanism assembly (M-U675) after attaching the assist frame sub
assembly to the mechanism assembly when replacing the mechanism assembly.
75. Apply oil where the platen lever assembly touches the main frame.
Figure 2-87
102
Screw (C.B.S-tite F, 3X4)
643 Paper feed frame shaft
Platen unit
Main frame
717
Screw (C.C., 3X5)
166
Assist frame sub assembly
717 Screw (C.C., 3X5)
G-36