Rev.D Assembly and Disassembly 2-97
TM-U675/U675P (with autocutter) Service Manual
Confidential
3. Insert the two tabs on the mechanism assembly (M-U675) into the two slits in the
strengthening plate.
4. Position the nibs and nib holes shown in the illustration and attach the two insulator spacer
assemblies. The flange of the metallic insulator spacer should be facing downward.
5. Fasten the mechanism assembly (M-U675) using one screw.
Note:
The assist frame sub assembly is not included in the mechanism assembly supplied as a service part
.
Figure 2-98
106 Screw (C.B.S-tite F, 3X6)
600 Mechanism assembly (type BB)
nsulator spacer
ssemblies
Nibs
Nib holes
Flange of
the metallic insulator spacer
To Next Page
Loading...
