Rev.D Assembly and Disassembly 2-99
TM-U675/U675P (with autocutter) Service Manual
Confidential
10. Pass the power switch cable assembly between the L-shaped piece in the main plate sub
assembly and the QM6 element on the main circuit board unit, as shown in the illustration.
11. Use insulated tape on the areas shown in the illustration to secure the power switch cable
assembly temporarily.
12. Connect the two circuit board FFCs to the main circuit board unit and the mechanism
assembly (M-U675) in that order. Bend the FFCs so that the fold is on the main circuit board
side.
Figure 2-100
206
Circuit board FFC
Tape
203 Power switch cable assembly
QM6
203
Power switch cable assembly
L-shaped piece in the main plate sub assembly
To Next Page
Loading...
