Rev.D Assembly and Disassembly 2-105
TM-U675/U675P (with autocutter) Service Manual
Confidential
23. Lubricate the hole in the axis of the take-up gear.
24. Insert the take-up spring into the take-up pulley while aligning the craw on the spring into
the pulley.
25. Remove the take-up pulley and lubricate the take-up spring attached to the take-up gear.
Reattach the take-up pulley.
26. Attach the take-up gear to the take-up frame assembly.
Figure 2-106
151 Take-up spring
146 Take-up gear
152 Take-up pulley
105 E-ring (2)
147 Take-up frame assembly
G-36
G-36
To Next Page
Loading...
