2-118 Assembly and Disassembly Rev.D
Confidential
40. Connect the autocutter cable assembly and the cutter lead wire assembly.
41. Insert the connector that you have just connected to the cutter plate cover, as indicated in the
figure. Pass one side of the lead wire through the slit in the cutter plate cover.
42. At the same time, position the other end of the lead wire into the cut-out portion in the cutter
plate cover; fasten the cutter plate cover to the cover frame sub assembly with one screw.
Figure 2-119
192 Cutter lead wire assembly
209 Autocutter cable assembly
165 Cutter plate cover
Cut-out portion
Slit
187 Switch screw
175 Cover frame sub assembly
195 Ferrite core
195 Ferrite core
To Next Page
Loading...
