Rev.D Assembly and Disassembly 2-123
TM-U675/U675P (with autocutter) Service Manual
Confidential
49. Align all tabs on the upper and lower cases. When doing so, do not allow the cable wire to
become pinched between the cases.
50. Push the cable wire for the paper ejection detector cable assembly (type A) connector into
the hole in the upper case. Then, route the cable wire for the paper ejection detector cable
assembly (type B) as shown in the illustration at right, so that it is not in the way of the
ribbon cassette.
Figure 2-124
To Next Page
Loading...
