Rev.D Adjusting and Setting 3-3
TM-U675/U675P (with autocutter) Service Manual
Confidential
2. While pressing the tab of the lever drive coil (type B), rotate the lever motor reduction gear
in the direction indicated in the illustration, so that the protrusion on the lever drive gear
faces the very bottom of the printer.
Figure 3-2
3. Remove your finger from the claw of the lever drive coil (type B). Check that the claw
returns to its original position. Redo from step 1 if it has not returned to its original position.
Figure 3-3
A
A
A
Lever motor reduction gear
Lever drive gear protrusion
Lever drive gear
Lever drive coil (type B)
To Next Page
Loading...
