Epson TM-U675 - Page 64

2-30 Assembly and Disassembly Rev.D
Confidential
4. Attach the sub paper feed roller assembly and the crank shaft holders to the paper feed
frame assembly.
5. Lubricate the areas where the sub paper feed roller assembly and the crank shaft holder are
in contact.
6. Attach the parallel pin and paper feed gear to the sub paper feed shaft with two E-rings.
Figure 2-30
722
E-ring (4)
730
Crank shaft
holder
699 Sub paper feed roller assembly
699
Sub paper feed roller assembly
730 Crank shaft holder
602 Parallel pin (1.6X10)
602
648 Paper feed gear
722 E-ring (4)
G-48
G-48