342
Caution: Leave your old cartridges in the printer until you are ready to replace them to prevent the print
head nozzles from drying out. Do not open ink cartridge packages until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
1. Open the ink cartridge cover.
2. Push in the ink cartridge that you want to remove until it pops out, then slowly pull it all the way out.
Note: Dispose of used cartridges carefully. Do not take the used cartridge apart or try to refill it.
3. Gently shake the new ink cartridge horizontally back and forth about 15 times, then remove it from its
package.
Caution: Do not remove any labels or seals, or ink will leak. Do not touch the green chip or the ink
supply port on the cartridge. Install the new cartridge immediately after removing the old one; if you
do not, the print head may dry out and be unable to print.
Warning: If ink gets on your skin, wash it thoroughly with soap and water. If ink gets into your eyes,
flush them immediately with water. If ink gets into your mouth, spit it out and see a doctor right away.
Keep ink cartridges out of the reach of children.
4. Insert the new cartridge and push it all the way in until it clicks into place.
5. Close the ink cartridge cover.
The home screen appears and the product starts charging the ink. This may take a few minutes. A
status message counts down until the product is ready. When the status message disappears, ink
replacement is complete.
To Next Page
Loading...
Need help?
General
