359
LCD screen message Condition/solution
Cannot print because XX is out of
order. You can print from another
cassette.
Turn the product off and then back on again. Reinsert the
indicated paper cassette. If the error persists, contact Epson for
support.
HDD error. Turn the printer off and
back on again. If the error continues,
contact Epson support.
The hard disk drive is damaged. You may not be able to receive
faxes (models equipped with optional fax board) or copy or print
documents that contain images. Copying more than 50 pages of
Text & Image A4 documents may fail. Contact Epson for
support.
XX are nearing the end of their
service life.
A consumable part in your product needs to be replaced.
Contact Epson for support.
XX are nearing the end of their
service life.
Contact Epson for support.
XX is at the end of its service life.
Replace it.
You need to replace the following ink
cartridge(s). Confirm the procedure,
and then replace them.
Replace the indicated ink cartridge(s).
No dial tone detected. (models with
optional fax board installed)
Make sure the phone cable is connected correctly and the
phone line works. If you connected the product to a PBX (Private
Branch Exchange) phone line or Terminal Adapter, change the
Line Type setting to PBX. Use # instead of the actual access
code when entering an outside fax number. If you still cannot
send a fax, turn off the Dial Tone Detection setting. (Turning off
the Dial Tone Detection setting may cause the product to drop
the first digit of a fax number.)
Failed to receive faxes because the
fax data capacity is full. Touch the
Job/Status at the bottom of the Home
Screen for details. (Models equipped
with optional fax board)
Select Job/Status > Printer Status and resolve any errors that
are preventing faxes from printing. Make sure the product is
connected to a computer and it is turned on, or connect a
memory device to the product.
The combination of the IP address
and the subnet mask is invalid. See
your documentation for more details.
There is a problem with the network connection to your product.
Set up your product on the network again.
To Next Page
Loading...
Need help?
General
