Related Information
& “E-1” on page 33
& “E-2, E-3, E-7” on page 33
& “E-5” on page 34
& “E-6” on page 34
& “E-8” on page 35
& “E-9” on page 35
& “E-10” on page 36
& “E-11” on page 36
& “E-12” on page 37
& “E-13” on page 37
& “Message on the Network Environment” on page 38
E-1
Solutions:
❏ Make sure the Ethernet cable is securely connected to your printer and to your hub or other network device.
❏ Make sure your hub or other network device is turned on.
❏ If you want to connect the printer by Wi-Fi, make Wi-Fi settings for the printer again because it is disabled.
E-2, E-3, E-7
Message:
No wireless network names (SSID) found. Conrm that the router/access point is turned on and the wireless
network (SSID) is set up correctly. Contact your network administrator for assistance.
No wireless network names (SSID) found. Conrm that the wireless network name (SSID) of the PC you wish to
connect is set up correctly. Contact your network administrator for assistance.
Entered security key/password does not match the one set for your router/access point. Conrm security key/
password. Contact your network administrator for assistance.
Solutions:
❏ Make sure your access point is turned on.
❏ Conrm that your computer or device is connected correctly to the access point.
❏ Tur n
o
the access point. Wait for about 10 seconds, and then turn it on.
❏ Place the printer closer to your access point and remove any obstacles between them.
❏ If you have entered the SSID manually, check if it is correct. Check the SSID from the Network Status part on
the network connection report.
❏ If an access point has multiple SSIDs, select the SSID at 2.4 GHz. e printer does not support SSIDs at 5 GHz.
❏ If you are using push button setup to establish a network connection, make sure your access point supports
WPS. You cannot use push button setup if your access point does not support WPS.
Network Settings
>
Checking the Network Connection Status
>
Printing a Network Connection Report
33
To Next Page
Loading...
Need help?
General