Managing Hardware with CLI Commands
Determining Operating Status 5-27
CCOD Mode State of CCOD mode port listening:
• on—Port listening mode is enabled.
• off—Port listening mode is disabled.
Clock Source • global-reference—Port is using the controller clock for transmitting.
• local—Port is using the onboard clock for transmitting.
• loop—Port is using the receive clock derived from the incoming signal on the port as the transmit clock
source.
Crc Configured value of the cyclic redundancy check for a SONET/SDH port (16, 32).
Dampening Count n—Number of instances this link-dampened ATM, Ethernet, or GE port went down and came up within
the limits set by the link-dampening feature.
Description Configured description.
Diag Monitor Status of this SFP transceiver with regard to monitoring SFP faults and reporting power readings:
• No—SFP cannot monitor its faults nor report power readings.
• Yes—SFP can monitor its faults and report power readings.
Duplex mode • full—Port condition, Ethernet or GE (any version).
• half—Port condition,10/100 Ethernet (FE) ports only.
Encapsulation Encapsulation for this port:
• 802.1q
•atm
• cisco-hdlc
• ethernet
• frame-relay
• ppp
Flow control Condition of flow control for GE port, any version, (on or off).
Framing Configured framing for the port:
•c-bit
• g751
•m23
• ESF
•SF
•sdh
• sonet
Idle Character Configured idle character (flags, marks).
Keepalive State of keepalive timer; if set, the configured value:
•Not set
• Set (10 sec)
Line SD BER 10E-5 to 10E-9—Signal degrade bit error rate for SONET/SDH port.
Line SF BER 10E-3 to 10E-5—Signal fail bit error rate for SONET/SDH port.
Table 5-31 Output Fields for the show port Command with the detail Keyword (continued)
Field Value/Description
To Next Page
Loading...
Need help?
General
