Interval Wiper
eSID3 adds a specialized wiper function that lets the user adjust the swipe interval. This works on
cars with and without rain sensor, and the sequence is:
1. Press and hold down the wiper stalk during an entire “swipe”. This will reset the interval time
2. When there is enough water on the windscreen to swipe again, do a single press on the
wiper stalk (a.k.a. single swipe). Now eSID3 will hold this interval since the first step above.
When the time has been set, the windscreen wiper will continue to run until the driver moves the
wiper stalk upwards into any other position than ”idle” or if the ignition is turned off.
If a vehicle travelling in the opposite direction passes by and totally “splashes” the windscreen, it is
just to activate a single swipe to clean the windscreen and the function is still activate and maintains
the selected interval.
To Next Page
Loading...