Torque Factor
Description
Torque factor is only used on B207 engines. The eSID3 uses the air mass signal to estimate the
torque, instead of using the torque signal from the engine controller due to it often being saturated
on tuned cars.
The estimated torque is calculated using:
Estimated Torque = Air mass / Torque factor [Nm]
Typical factor value is 3.1 for gasoline and 2.9 for E85, but may vary. Talk to your tuner.
Enable Criteria
B207 Engine
Configuration Options
2.0 – 4.0 (Note! Function is disabled if value is 2.0)
User Inputs
SET – Enter or Exit Edit mode (***)
INFO UP/DN – Change Setting in Edit mode.
To Next Page
Loading...