Force DPF Regeneration
(Only SW SG1.1.x and newer)
Description
eSID3 can force a DPF regeneration to start if the normal regen for some reason hasn’t been able to
complete (too many short driving cycles for instance). This shall be used as a last measure, always
use the cars normal regeneration function if possible and let it finish correctly once started.
eSID3 will show disable condition if it’s not possible to start the Regen, for instance if clutch is
applied, brake is applied or vehicle speed is too high.
Note: This function shall only be performed standing still on a flat surface outside, the
Engine will run at 3500 rpm constant for over 5 minutes and the DPF will get very warm.
Enable Criteria
Diesel Engine with DPF
User Inputs
SET – Start DPF regeneration (if all conditions are fulfilled)
To Next Page
Loading...