5 Layers and Instruments | 78
To reorder columns
1. Move a column by dragging its column header to the new position within
the table header.
A line between the columns appears together with highlighted areas on
the left and on the right of the line.
2. Select the left or right highlighted area to place the column in front of or
behind this line.
3. Release the mouse button.
To fill empty cells
1. If the value of a signal is not available, you can display its interpolated
value. In the table toolbar, click .
The empty cells are filled with the last available sample (so-called "step-
mode" or "constant interpolation"). These values are shown in gray italic
font.
2. To undo this action, click the icon again.
To change the number of decimals
1. Mark the columns for which you want to change the number of decimal
places.
2. In the toolbar, click one of the following icons:
l
To show more decimal places, click .
l
To show fewer decimal places, click .
The decimals for the time values can be adapted in the same manner.
To change the data representation of a signal
1. In the table, select one or more signals.
2.
In the toolbar, click .
3. Select one of the following entries from the Data Representation drop-
down menu:
l
Physical Values
l
Hexadecimal (memory) Values
l
Binary (memory) Values
l
Decimal (RAW) Values
All selected signal values are shown in the selected data representation.
The unit information is adapted according to the selected data rep-
resentation.
Note that if the device name of the signal ends with #MeasureCal, you
must additionally select which data type shall be used to display the val-
ues. Select one of the following:
l
8 bit
l
16 bit
MDA V8 | User Guide
To Next Page
Loading...
