ETAS MDA V8 - Using Axes

5 Layers and Instruments | 60
1. To move signals to separate strips, right-click the desired signals from one
strip or different strips.
2. Click Move to Individual Strip(s).
To delete a strip
1. Open the context menu of the strip that you want to delete.
2. Select Delete Strip.
Note that a strip is also deleted when the last signal of a strip is deleted.
5.2.2.5 Using Axes
You can perform the following actions:
"To assign signals using the selection wheel" below
"To use common axes" on the next page
"To use individual axes" on the next page
"To scroll axes" on the next page
"To scroll the time axis" on page62
"To zoom axes" on page62
"To adjust the axis range manually" on page62
"To predefine an axis range for a signal" on page62
"To set the default behavior for signal-to-axis assignment" on page63
"To delete axes" on page64
To assign signals using the selection wheel
To assign signals to an oscilloscope, you can use the selection wheel. It appears
when signals are assigned to an oscilloscope or moved within an oscilloscope via
drag and drop.
1. Drag the signals into the analog graphical area of the oscilloscope or to the
desired position in the signal list. After a short delay the selection wheel
appears.
2. Within the selection wheel, drop the signals onto one of the options:
One common axis for all signals
Assign all signals to one axis.
Shared axis per unit
Assign signals to an axis having the same unit.
Individual axes per signal
Assign each signal to an individual axis.
MDA V8 | User Guide