EverFocus EFC304 - 2 Installation; Installation Preparation; Obtain a Floor Plan

NAV IP Access controller

11
2. Installation
TheInstallationhasthreeproceduresdescribedasbelow.Eachprocedurewillbe
introducedinthefollowingsectionsindetail.



2.1InstallationPreparation
Beforeinstallation,usersareadvisedtocollectinformationproperlywhichwillmakethe
installationmoresmoothlyandhelpstoreducetimeandenergycost.Forprofessional
constructors,theinformationbelowwillbeofgreatuse.

2.1.1 ObtainaFloorPlan
Obtainafloorplanofthebuildinginwhichtheaccesscontrolsystemistobeinstalled.
Chapter
2
S
tep1:InstallationPreparation
 Obtainafloorplan
 Determinethehardwareandlocation
 Determine the number of controllers according to
systemstructure
S
tep2:HardwareInstallation
 Installingthecontroller
 Connectingtothedoorlock/openbutton/sensor/bell
 Connectingtothealarminput/output
 Connectingtothecardreader
 Connecting to the computer through the networkMount a
backupbatteryintheenclosure
S
tep3:
S
oftwareSetup/Configuration
 Logincontrollerbuilt‐insoftwarethroughIEoncomputer
 Setuseraccountforusersoftware
 Setcontrollerandotherequipment
 Setholidays,shiftsanddoorcontrolrules
 Logincardandsetcardattributes