EverFocus EFC304 - 7 Start to Use; Quick Start; Add and Configure Controller; Set Access Rule

To Next Page

To Previous Page

NAV IP Access controller

64

7. StarttoUse

ThischapterintroduceshowtoquicklysettingEverAccess®NAVControllerasasuper

administratorandusethecontrollertocontroldoorsandcollectattendancerecordsand

CCTVlinkagefunctionthroughbrowser.Pleasefollowthestepstogetfamiliarwiththe

software.Foramorecomprehensiveunderstandingofeachfunction,referchapterson

relatedtopics.



7.1QuickStart

7.1.1AddandConfigureController

In the main interface, click “AccessControl”  “Controller” “Controller Setting” enter to controller

settingpage.Thestepstoaddacontrollershownasfollowing(thedetailrefersto12.1.1).

Steps：

1) Clickthe“Add”button,inputcontrollermodenumber,locationandaddress.

2) Clickthe“Save”button.



SetAccessRule



7.1.2.1 Set Date

Clickonthemenubar“AccessControl”“AccessRule”“DateType”,entertodatetypepage.Below

ishowtoaddadatetype(Detailsettingsee13.1.1)

Steps：

1) Selectrecurrenttype.

2) Selectthedateincalendar.

3) Selectdatetype

4) Inputthedate remark.

5) Clickthe“Save”button.



Chapter