11
1-5b CONNECTING THE PRINTER
ä
Connection to the power supply
The printer must be connected to a properly protected and earthed electrical installation.
FI: Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan.
NO: Apparatet må tilkoples jordet stikkontakt.
SE: Apparaten skall anslutas till jordat uttag.
This is a Class B device. This equipment are intended for a use un residential environments but may alose be used in a non
residential environments.
The residential environment is an environment where the use of broadcast radio and television receivers may be expected
within a distance of 10 meters from where this product is used.
Ê
Plug the power cable connector into the printer.
Ë
Next, plug the end of the power cable into an earthed power socket.
Ì
Power up the printer by switching the switch to ON.
Í
[Initializing...] appears on the LCD, the operating indicator turns blue and [Ready] appears. If the LED indicator turns
orange/blinks refer to the troubleshooting section.
Before attempting any maintenance, always ensure that the power switch is in the OFF position and that the
power cable is unplugged. For your personal safety, ensure that both the switch and cable remain easy to
access, especially in the event of an emergency.
To save energy, the heater will automatically turns off after 1 hour of inactivity. For more information please see
the Reduce printer power consumption 4-5 section of this manual.
ä
Connecting the USB cable
Under no circumstances you must connect the USB data cable before the end of the installation of the printer
driver.
Refer to the section on printer driver installation for further details, and follow the instructions carefully.
1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
