30
ä
Changing Network connection settings
You can congure internet communications settings such as the individual printer ID and TCP/IP-related settings.
Ê
Switch from Normal Mode to User Mode
Ë
Press the Key until [Interface Setup] is displayed. Press the SET Key
Ì
Select the settings to change by using the t/s Keys. Press the SET Key to conrm.
Í
Change the settings by using t/s Keys. Press the SET Key.
For numerical values, use the t/s Keys to change each digit. Press the SET Key to conrm.
Î
Turn off and on the printer to enable the settings.
The factory default settings are [DHCP], [IPsec] and [Password] set to [OFF].
[Subnet Mask] and [Default Gateway] are set to [0.0.0.0].
[IP Adress] is set to [169.254.0.0].
[Printer ID] is set to [8].
[Timeout(s)] is set to [30].
You can also change the settings by using the printer driver.
2
Settings Menu Details
Printer ID Set the individual printer ID
DHCP Set the DHCP function ON/OFF
IP Address Set the IP addres (only when the DHCP function is OFF).
Subnet Mask Set the subnet mask (only when the DHCP function is OFF).
Default Gateway Display the default gateway (only when the DHCP function is OFF).
MAC Address Display the MAC address.
IPsec Set the IPsec function ON/OFF
Timout(s) Set the session timeout (seconds).
Password
Set the password ON/OFF for settings TCP/IP using the printer driver.
If the password is on, set the password.