Evolis Avansia - Card Positioning

72
ä
Card positioning
You can set the orientation of loading magnetic cards.
You can also change the settings by using the printer driver.
This setting is only available when the optional encoder unit is attached.
Ê
Switch from Normal mode to User mode.
Ë
Press the t Key until [Card Setup] is displayed. Then press the SET Key.
Ì
Press the t Key until [Set card side] is displayed. Then press the SET Key.
Í
Change the settings [Standard] or [Reverse] by using t/s Keys, then press the SET key.
Ê
Open the Top cover.
Ë
Open the card feeder.
Ì
Insert magnetic cards depending on the mode.
Í
Close the card feeder and the top cover.
The factory default setting is [Standard].
Printing on the magnetic strip terminal cannot be guaranteed.
[Standard] : [Reverse] :
B