Installation site!
The machine must not be operated in the open air and must only be set up and
operated on a suitable, stable and level base!
• The operator must ensure that the ground is non-slip and level, and provide sufficient
lighting for the place of work.
• Safe operation of the machine must be guaranteed at all times.
Risk of falling!
If the wire feed unit is not properly placed on the support, it can fall down and cause
injuries.
• The inner feet of the machine have to be properly inserted into the recesses!
• The wire feed unit has to be level with the outer support frame!
• Check that the units are properly secured before any transport and every start-up
operation!
• Observe the safety instructions on transport and setup, as well as on lifting by crane, in the
operating instructions for the power source or for the wire feed!
• Do not apply tractive force to the torch hose package!
• Do not use the press arbor device!
To Next Page
Loading...
