Getting Started with Your Unit
46 FTB-2/FTB-2 Pro and FTB-4 Pro
Inserting and Removing Test Modules
To insert a module into the unit:
1. If you are working with an FTB module, turn off your unit (shut down,
not hibernate or sleep). Otherwise, you can go directly to step 2.
2. Position the unit so that its right panel is facing you.
CAUTION
Your unit is compatible with some of the FTBx modules and some of
the FTB modules. For a list of supported modules, refer to your
unit’s technical specifications. To avoid damaging your unit, use it
only with modules approved by EXFO.
IMPORTANT
You can insert FTBx modules, FTB modules, or a combination of
both in your unit. However, to be able to work with the FTB
modules, you need to first install module adapters. These adapters
must be removed before inserting FTBx modules. For more
information on how to install or remove the module adapters, see
the corresponding section in this documentation.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
