Optical Explorer 123
8 Managing Test Results
You can view measurements directly from your unit. You can also manually
delete measurements that are not part of a TestFlow job by selecting all
measurements or some of them only. You cannot delete measurements
that are part of a TestFlow job but you can perform a measurement that
has already been done again. See Performing a Measurement Again on
page 165 for details.
If you need to generate measurement reports you can use the TestFlow
mobile application. See Generating Measurement Reports on
page 132, and Generating Job Measurement Reports on page 169.
Note: You cannot transfer measurements from your unit to a computer by
connecting them with a USB cable.
Viewing Measurements
Every time you perform a measurement, the unit saves it under a
sequential name generated automatically.
The names are built as followed:
OLX-<Sequential_number>
where
Sequential_number corresponds to a number that increases from 000 to
999.
Once this number reaches 999, it is reset to 000 automatically. Any existing
measurement bearing the same name as the new measurement is
overwritten.
Note: The unit will prompt you before resetting the name.
Measurements are visible from their dedicated list (accessible via the main
menu) and from Fiber Xplorer.
To Next Page
Loading...