Working With the TestFlow Mobile Application
Optical Explorer 159
Transferring a TestFlow Job to the OX1
Transferring a TestFlow Job to the OX1
Once you have created a TestFlow job or someone from your organization
has created one and has assigned it to you, you have to synchronize the job
with your OX1 to be able to perform the associated tests. The transfer is
done via Bluetooth
®
.
You can retrieve a brand new job from the TestFlow mobile application.
You can also resume a job that has already been started by someone else
on another unit and transfer it to the OX1 you are using for your tests.
Note: No results are erased from your OX1 when you switch between jobs.
As soon as a job is retrieved from the TestFlow mobile application, it is set
as the current job even if there was already a job underway. The results of
the tests in the job that was already started are kept in memory and you
will be able to synchronize them with the TestFlow mobile application
later. To do so, you will have to set the job as current again to be able to
perform the synchronization process. When the current job changes, the
tests that have not been performed yet on the previous job will be available
the next time you switch back to this job.
Note: You can only synchronize one job at a time.
To Next Page
Loading...