Working With the TestFlow Mobile Application
Optical Explorer 167
Synchronizing Job Results With the Smart Device and the Cloud Server
Synchronizing Job Results With the Smart
Device and the Cloud Server
The TestFlow mobile application manages the measurements associated
with jobs automatically for you.
The synchronization of the results is done in two steps. You can start the
synchronization process as soon as a Bluetooth
®
connection is established
between your unit and the smart device. Test results are sent to the mobile
application to allow report creation without fulling the smart device’s
memory. By sending the results to the TestFlow mobile application, you
can synchronize the entire job or the tests already done in a job. This way,
you can resume a job that has already been started by someone else on
another unit and transfer it to the OX1 you are using for your tests. You
cannot view the details for the tests already completed and transferred to
another unit. Only the final status is available.
The test results will be sent automatically from your unit to the cloud server
via a Wi-Fi connection in a subsequent step. The data is erased from the
unit as soon as this step is complete.
Note: To perform a synchronization, the job currently loaded on the OX1 must
also be the one selected in the TestFlow mobile application. The tests
completed in another job are kept in memory on the OX1 until the results
are synced with the TestFlow mobile application.
When a synchronization is in progress with the smart device or the cloud
server, no data is lost if the battery level of the unit is too low or your OX1 is
disconnected from the Wi-Fi network. The synchronization process
resumes once the OX1 is connected to a power outlet and a Wi-Fi
connection is established.
To Next Page
Loading...