EXFO Optical Explorer - Working with the Testflow Mobile Application

Optical Explorer 135
9 Working With the TestFlow
Mobile Application
You can use your OX1 in association with a smart device equipped with the
EXFO TestFlow mobile application allowing you to document your results,
archive them on a cloud server, and generate reports.
Note: In addition to all the other features explained throughout this
documentation, you also have access to the features presented hereafter if
you work with TestFlow jobs.
Note: The TestFlow mobile application gives you access to certain features even if
you do not log on to your TestFlow account. However, to benefit from all
the available features, you will need to log in. The procedures presented
throughout this user documentation will indicate if a logon is required.
At any time, you can switch from local measurements (that are not part of
a TestFlow job) to measurements within a TestFlow job. All the
measurements are kept in memory. You can also open, in turn, the power
checker and the source page.
Note: Depending on the type of smart device you are using, the appearance of the
Optical Explorer tool (available from the TestFlow mobile application) may
vary slightly from the illustrations presented in this documentation. Unless
otherwise specified, the information applies both to the Android- and
iOS-based smart devices.
Note: The measurement units used on your OX1 are independent from those
used in the TestFlow jobs. This means that you may have to make changes
to ensure consistency in the selected measurement units.