Maintenance
Optical Explorer 193
Replacing the Click-Out Optical Connector (Pro Units Only)
5. Place the Click-Out connector back in the unit (see the corresponding
procedure in Replacing the Click-Out Optical Connector (Pro Units
Only) on page 193).
6. Perform an optical output test again.
7. If the ratng remains low (three stars or less), you could repeat the steps
above. If after a couple of tries the rating remains low, it probably
means that the internal connector needs to be replaced. In this case,
contact EXFO (see Service and Repairs on page 230).
Replacing the Click-Out Optical Connector (Pro
Units Only)
All Pro units come with a Click-Out optical connector that you can replace
should you need a different connector type (APC or UPC), or should it
become damaged with time. You can purchase new Click-Out connectors
from EXFO.
If your unit is not equipped with a Click-Out optical connector and the
connector has to be replaced, you need to contact EXFO (see Service and
Repairs on page 230).
To Next Page
Loading...