Working With the TestFlow Mobile Application
Optical Explorer 165
Performing a Measurement Again
Performing a Measurement Again
All measurements are performed the same way either you are using your
OX1 with or without a TestFlow job. See Performing Measurements on
page 92.
However, you can redo a measurement that has already been taken in a
job.
Note: When a measurement is underway, the navigation arrows are disabled
and you cannot browse through the measurements you have already
performed.
IMPORTANT
Once you redo an existing measurement, the previous result is
deleted. Only the new result will be available when the
measurement is complete.
To Next Page
Loading...